510 LR Long Barrel Bridgeless 1.5ohm Atomizer (Cisco Spec)
Cisco Spec Low resistance bridgless long barrel dripping atomizerrs . These will work on any 510 connector including bottom feeders as the center post is open.
These atomizers are custom designed with a low resistance coil (1.5ohms) and create thicker and more flavorful vapor on larger e-cig batteries and mods that use single cell Lithium 3.7v batteries or varible volt/variable wattage devices. Thes 510 ataomziers are designed with a 37mm longer barrel/tube, 10mm longer than standad 510 atomizers. This helps with heat transfer and also with liquid that tend to spit. These atomizers are for dripping only and require a drip tip or juice feed system, cartridges will not feed juice to the coil with the absence of a bridge. There is little to no primer fluid used in manufacturing of these atomizers, please drip 4-5 drops of e-liquid on any new atomizer, give the liquid 30 seconds or so to soak in and wet the coil, drop another 2-3 drops just before vaping, take a cold pull and listen for a slight gurgling sound, if not add a drop or two more and test again. Do not run the atomizers dry as this puts excess stress on the coil and could permanently damage the coil.
There is a learning curve inherent with LR atomizers and you need to understand how to use them properly and not damage them. I don't recommend these atomizers for users who are new to vaping unless they understand the proper use. There is no warranty on these atomizers, they are guaranteed to not be DOA.
Nickel Plated Threads with etched Center Post
Avalable in Black and Stainless