The AMP Tank is the tank that drippers have been waiting for. Dedicated drippers are uncompromising when it comes to getting the most flavor and vapor from their juice. They are willing to do a little extra work rather than sacrifice flavor for the convenience of a cartomizer. The AMP Tank is a standard 510 submersible atomizer tank using unmodified standard 510 atomizers. With the AMP Tank the 510 atomizer is threaded into a connector that is inside the liquid tank allowing you to open the space between the atomizer connector and the base connector and increase or decrease the amount of liquid flowing into the atomizer. The thickness of the juice will determine how one would use the AMP Tank. Those who use thinner juices will be able to instantly enjoy the AMP Tank experience. Those with thicker juices would take advantage of the AMP Tank's adjustability and manual feed feature. There is a small hole on the outside radius of the valve bushing where the air enters. This valve bushing is permanently affixed internally to the 510 atomizer connector inside the tank. The bottom cap and valve bushing can rotate independently, twisting the tank section counter clockwise while holding the valve bushing section will open the space between connectors and  expose more of the air intake holes in the atomizer threads to increase juice flow. Adjusting the liquid flow does not require removal of the atomizer or draining of the tank. There is a tool available to increase the size of these holes to further improve juice flow. This might be necessary with thicker liquids, particular manufacturer’s atomizers, or very light draw speeds. Every draw on the atomizer designates (determined by the space between connectors and draw speed) a portion of the vacuum you create to feeding new liquid into the atomizer. The amount of liquid that will “auto”  feed is determined by the space between the atomizer and connector as well as the viscosity of your liquid and draw speed. The final feature of the AMP Tank is the ability to manual feed at any time. This feature enables the user to temporarily interrupt the air flow (holding your finger over the air intake and taking a cold pull) so that only liquid is pulled into the atomizer. This feature is necessary if your atomizer/liquid setup will not auto feed enough liquid.  Never use the manual feed feature without vaping directly after, bringing excess liquid into the atomizer and not making use of it could cause the atomizer to flood. If the atomizer is flooded or over fed its possible liquid could leak from the air intake hole. It will require a bit of time to figure out the setup that works best for you. Because of the variety of atomizers/ liquids/ draw speeds we cannot make the claim this will fully auto feed for everyone. This is an experienced user product, we do not recommend these for new users or users who are not experienced with atomizers and dripping. It is recommended to prime and break in any new atomizers before setting up in the tank. We do not recommend unthreading the atomizer from the connector more than 1/2 rotation maximum,  1/4 turn is typically sufficient. Opening the atomizer more than 1/4 to 1/2 rotation can actually reduce the feed rate and increase the potential for an air lock restricting the liquid feed.

Amp Tank Kit Includes:

 1x Amp Tank (top and bottom caps, valve)

1x 3ml 26mm Fused Quarts tube (standard length 510)

1x 5ml 40mm Fused Quartz tube (Long barrel 510)

1x 510 Atomizer extender (extends standard 510 atomizer for use in the 5ml Long Barrel tank)

1x 1.5 ohm Cisco Spec 510 Stainless bridgeless atomizer (email if an alternate ohm is required )

Note on Glass: The glass tubes are made from Fused Quartz. The cut edges are flame polished to produce a clean look. Small chipping may show on some of the cut surfaces, this will not effect the function of the glass.