Categories

Categories

Additional Information

Additional Information

Account Navigation

Account Navigation

Currency - All prices are in AUD

Currency - All prices are in AUD
 Loading... Please wait...
Avid Vaper

Categories

Categories

Aspire Atlantis Replacement coils

$2.49

Aspire Atlantis Replacement coils

$2.49
Share

Product Description

aspirelogo.jpg

Aspire Atlantis Replacement Coils

Replacement coil for the Aspire Atlantis Sub ohm tank. Coils are 0.5 ohm

Price is per single replacement coil. Discounts for 5pcs +

+/- 0.1ohm manufacturing tolerance.

 

 

 

 
 
 
 
 
 
 
How to Use your Aspire Atlantis Tank:

To fill, turn the tank upside down and remove the threaded end cap.  Fill the outer portion of the tank (avoid getting e-liquid into the center airflow tube) and then screw the end cap back onto the tank tightly.  You can now turn it rightside up and check for leaks before using.

Gurgling or Leaking can occur if liquid gets into the center airflow tube.  To clear this liquid and improve performance remove the tank from the battery and blow through the mouthpiece into a paper towel.  The excess liquid will come out of the threaded end of the device.  If this happens often you may need to check that all connections are screwed down tightly or replace the head and wick assembly with a new one.

The head and wick assembly can sometimes loosen itself when the threaed end cap is unscrewed.  Always check that it is pushed into the bottom cap tightly tightly before screwing the cap back on.  Not doing so could result in a leaking or non-working device.

You should never run the tank completely dry.  Doing so could result in a burnt or damaged wick and can cause leaking.  Refill the tank when the liquid level reaches approximately 1/3 full

The lifespan of replacement heads can vary quite a bit, but following the above instructions will maximize the lifespan of the coil. Replacement Heads for this product can be found here

 
Prime new coils with 3-4 drop of liquid, avoiding the center hole. Allow 1 to 2 minutes for the liquid to properly feed into the coil.
Avoid getting eliquid into the tube in the center on both the tank and the coil head, the center hole is for airflow only.

 

Warning: This tank uses a sub-ohm resistance atomizer (0.5-0.7ohm)  You must be sure that your mod and batteries can handle SUB OHM coils. If you're using an electronic mod, make sure it can handle the amps. For mechanical mod users, please use 10 Amp batteries or higher. On mechanical mods .5 ohms will require 8.4Amps @ 4.2v ( 35Watts)

Warranty Information

Product Reviews

Find Similar Products by Category

‚Äč