Additional Information

Additional Information

Account Navigation

Account Navigation

Currency - All prices are in AUD

Currency - All prices are in AUD
 Loading... Please wait...
Avid Vaper



Aspire Nautilus BDC Adjustable Air Flow Clearomizer


Aspire Nautilus BDC Adjustable Air Flow Clearomizer


Product Description

aspirelogo.jpgAspire Nautilus BDC Adjustable Air Flow Glass Clearomizer

The Nautilus Dual bottom coil glass clearomzier is a  new style of bottom coil clearomizer tanks featuring a wickless dual coil heating element. These features provide increased vapor while also taking advantage of a bottom liquid feeding design so that the coils are always being fed just enough juice, no more fighting gravity!! The Nautilus has an exclusive adjustable airflow design, with a simple turn of the lower ring, you have four preset options to adjust airflow. The tank has a capacity of approximately 4.8ml of e-liquid and it comes pre-loaded with a 1.6ohm dual coil head and an additional 1.8ohm coil head. The Nautilus also features a 22mm diameter and has a flush fit on most flat top 510 devices.


  •  Stainless Steel Construction
  • Adjustable Airflow Control
  • Pyrex glass tank ( approximately 4.8ml)
  • BDC (Bottom Dual Coil) Technology
  • Avaialble in 1.6ohm and 1.80hm resistance
  • 510 and 510/eGo connector compatible
  • Removable Dri pTip
  • 22mm x 59mm (without drip tip)


Aspire Nautilus kit Includes:

  • 1x Full Aspire Nautilus Tank (1.6ohm BDC coil pre-installed)
  • 1x Extra Aspire Nautilus 1.8ohm BDC coil
  • 1x eGo cone
  • 1x User Manual
  • 1x Gift Box




How to Use your Aspire BDC:

To fill, turn the tank upside down and remove the threaded end cap.  Fill the outer portion of the tank (avoid getting e-liquid into the center airflow tube) and then screw the end cap back onto the tank tightly.  You can now turn it rightside up and check for leaks before using.

Gurgling or Leaking can occur if liquid gets into the center airflow tube.  To clear this liquid and improve performance remove the tank from the battery and blow through the mouthpiece into a paper towel.  The excess liquid will come out of the threaded end of the device.  If this happens often you may need to check that all connections are screwed down tightly or replace the head and wick assembly with a new one.

The head and wick assembly can sometimes loosen itself when the threaed end cap is unscrewed.  Always check that it is pushed into the bottom cap tightly tightly before screwing the cap back on.  Not doing so could result in a leaking or non-working device.

You should never run the tank completely dry.  Doing so could result in a burnt or damaged wick and can cause leaking.  Refill the tank when the liquid level reaches approximately 1/3 full

The lifespan of replacement heads can vary quite a bit, but following the above instructions will maximize the lifespan of the coil. Replacement Heads for this product can be found here:

BDC: Bottom Dual Coil

BVC: Bottom Vertical Coil 

After the first fill please allow 1 to 2 minutes for the liquid to properly feed into the coil.
DO NOT feed eliquid into the tube in the center. The center hole is for airflow only.
1x Aspire CE5 Stainless Sleeve clearomizer (eGo Thread)
1x Removable black acrylic mouth piece
2x Coil Heads ( x 1.8ohm,  1x 2.1ohm)
1x Gift box

Warranty Information

Product Reviews

Find Similar Products by Category