Aspire Nautilus BDC Replacement Coils
These replacement coil heads are designed to fit the Aspire Nautilus tank system only. These coils WILL NOT fit the any of the other Aspire BDC products. These replacement heads feture a dual coil desing for maximum performance.
Available in 1.6ohm and 1.8ohm
How to Use your Aspire BDC:
To fill, turn the tank upside down and remove the threaded bottom cap. Fill the outer portion of the tank to jsut below the top of the center tube (avoid getting e-liquid into the center airflow tube) and then screw the end cap back onto the tank snug. You can now turn it rightside up and check for leaks before using.
Gurgling or Leaking can occur if liquid gets into the center airflow tube. To clear this liquid and improve performance remove the tank from the battery and blow through the air hole into a paper towel postioned at the mouth piece. If this happens often you may need to check that all connections are screwed down tightly or replace the head and wick assembly with a new one.
You should never run the tank completely dry. Doing so could result in a burnt or damaged wick and can cause leaking. Refill the tank when the liquid level reaches approximately 1/4 full
The lifespan of replacement heads can vary quite a bit, but following the above instructions will maximize the lifespan of the coil.