Loading... Please wait... 
Categories
Categories
Brands
Brands
- Home
- Clearomizers
- Aspire BDC BVC Clearomizers
- Aspire Atlantis Sub Ohm Tank
Aspire Atlantis Sub Ohm Tank
Product Description
Aspire Atlantis Tank
Aspire's Atlantis has raised the bar to new heights. This next generation tank system brings improved adjustable airflow and Sub Ohm coils that provides performance similar to even the best rebuildable atomizer. By enhancing Aspire's Bottom Vertical Coil design Vapers will experience better taste and vapor production. Aspire's Atlantis Tank design is easy to carry, install, and refill.
The Aspire Atlantis tank comes with a standard 510 atomizer connection, adjustable preset air flow from 2mm to 9mmx2.6mm slot), repalceable sub ohm coil, glass tank, The Aspire Atlantis can run from 20-30 watts and comes with a 2ml eliquid capacity. If you have been looking for great vapor production on a tank system, the Aspire Atlantis atty is the best on the market and will change the way you vape on a coil tank system. this is one of the best performing replaceable coil tanks on the market. Atlantis Replacement copils can be found here.
Features:
- 510 Threaded
- Capacity: 2ml
- Glass Tank
- Stainless steel
- Patented Aspire BVC Sub ohmTechnology
- Available resistance: 0.5-0.7ohm (Sub-Ohm 20-30W)
- Air hole size: 2mm, 2.8mm, 6*2.6mm slot, 9*2.6mm slot
- Upgraded adjustable airflow system
- Uses the new Atlantis BVC (bottom vertical coil) sub ohm Replaceable Coil
- Replaceable glass tank
- 510 Drip tip compatible
- 22mm Diameter (will work with 510 hybrid adapters)
- 1 x Atlantis Tank
- 1 x Spare Glass Tube
- 2 x Atomizer Head - 0.5ohm
- 1 x Drip Tip
- 1x Plastic box
To fill, turn the tank upside down and remove the threaded end cap. Fill the outer portion of the tank (avoid getting e-liquid into the center airflow tube) and then screw the end cap back onto the tank tightly. You can now turn it rightside up and check for leaks before using.
Gurgling or Leaking can occur if liquid gets into the center airflow tube. To clear this liquid and improve performance remove the tank from the battery and blow through the mouthpiece into a paper towel. The excess liquid will come out of the threaded end of the device. If this happens often you may need to check that all connections are screwed down tightly or replace the head and wick assembly with a new one.
The head and wick assembly can sometimes loosen itself when the threaed end cap is unscrewed. Always check that it is pushed into the bottom cap tightly tightly before screwing the cap back on. Not doing so could result in a leaking or non-working device.
You should never run the tank completely dry. Doing so could result in a burnt or damaged wick and can cause leaking. Refill the tank when the liquid level reaches approximately 1/3 full
The lifespan of replacement heads can vary quite a bit, but following the above instructions will maximize the lifespan of the coil. Replacement Heads for this product can be found here
Warning: This tank uses a sub-ohm resistance atomizer (0.5-0.7ohm) You must be sure that your mod and batteries can handle SUB OHM coils. If you're using an electronic mod, make sure it can handle the amps. For mechanical mod users, please use 10 Amp batteries or higher. On mechanical mods .5 ohms will require 8.4Amps @ 4.2v ( 35Watts)
