The T3S and MT3S is the newest in the line of bottom coil clearomizers from Kanger. 

The MT3S/T3S's have approximately 2.4ml of liquid capcity

The replaceable coil screws into the bottom cap of the MT/T3S clearomizer.  Simply unscrew the bottom cap and replace with a new head without the need to empty your remaining liquid from the tank.

To fill the MT/T3S, turn the clearomizer upside down, and remove the bottom thread assembly.  Tilt the MT/T3S at a slight angle, fill with 2.4ml of your favorite e-liquid.  Do not allow liquid to flow in to the center air hole tube. 
Replace the bottom thread assembly, wait 2-3 minutes and it is now ready to be used.

Includes one T3S/MT3S clearomizer replacement coil

 Available in:

1.5ohm

1.8ohm

2.2ohm

2.5ohm

Be sure to check and tighten the Bottom coil, after filling with liquid.
This will ensure that no leaking will occur.